NX Design Simulation - Basic Training
Our NX Design Simulation Basic Training allows you and your employees to efficiently use NX Design Simulation and gives you useful technical insights for your dayly work.
Description
This training is for designers and engineers looking for an efficient entry into FE calculation with NX Design Simulation.
Requirements
Knowledge of strength theory and mechanics, fundamentals of the FE-Method
Content
- Introduction to NX Design simulation workflow
- Geometry preparation, idealization
- Meshing techniques 3D
- Material properties
- Boundary conditions, constraints and loads
- Solving linear statics, eigenvalues, buckling, thermal
- contact and glue
- Postprocessing
Language
German / Englisch
Speaker
Andres Graf
Participants
Minimum 3 / maximum 6
Costs
CHF 700.00 per participant
Course Location
AeroFEM GmbH, Aumühlestrasse 10, Ennetbürgen
Registration
Please send us your application in written form, e.g. by e-mail or via our webpage. Cancellations two weeks prior to the course can be accepted without charge. For later cancellations, full costs will be charged. Any cancellation must be in written form.
Contact us for more information
Andres Graf
M.Eng., Dipl. Masch.-Ing. FH